Blog

Sump Pump Tragedies

Sump pumps are often the difference between a regularly flooded basement and a dry usable space. But, how would you know the condition of your sump, or what can harm your otherwise healthy sump pump system? Here are some events that can lead to the end of your Sump pump system. 

1. Failing Sump Pump Float Switches 

Float Switch Inside Sump System

Many sump pump systems are activated by a floating part known as a float switch. As the water rises in your sump pump, the switch floats upwards.  When it reaches a certain height, it automatically turns your system on.  As the water level in your sump pit drops, the switch falls with it, and the system turns off.  

One of the most notorious causes of sump pump failure is when this float switch is trapped in either the on or off position.  This happens as the vibrations of the sump pump cause the unit to wander in the sump pit.  As the pump reaches the edge of the pit, the switch can become stuck against the liner and will no longer automatically turn on or off. 

If stuck in the on position, the system will run nonstop until it eventually burns out.  If left in the off position, the system is disabled.  If you don't have a battery backup in place, you'll most likely discover this problem the next time your basement floods.

2. Improperly Sized Sump Pits 

A sump pit can be neither too small nor too large.  If the pit is too small, then the sump pump will empty the pit quickly and shut off.  More water will quickly fill the pit, and the cycle will repeat. This constant on/off cycle wears your system out and increases the likelihood of its overheating and breaking down.  

A sump pit that's too large will also likely be too deep – and therein lies the problem.  If your sump pit reaches deep below the floor, then it's gathering much more water than it needs to – and it's forcing your pump to work longer and harder to pump water out.  This will unnecessarily shorten the life of your system, increase the likelihood of overheating, and cost you extra on your electric bill.

3. The “Mud Zone”  

There are two places where a drainage system can be installed:  on top of your home's foundation footing, or in the mud in front of the footing – known as the mud zone. 

When a drain system is installed in the mud, it clogs.  Even in cases where drainage stone is installed around the drain, the mud will eventually work its way through and cause a clog.  When this happens, your system will be unable to direct water to your sump pump, and a flood will occur.  

Typical PVC pipe is too large to be installed properly on ton of the footing without sticking out above the floor.  Instead, it's important to use a drain system that's been shaped specifically for basement waterproofing.  This system can rest directly on top of the footing, but is narrow enough to be covered with concrete as the floor is restored.  

4. Iron Bacteria  

Iron Ochre

One uncommon – but notorious – cause of sump pump system failure can be credited to iron bacteria in your water.  This microscopic organism will feed on the iron and/or manganese present in your water.  As they feed, they create a thick, rust-colored slime deposit. 

This is a terrible problem!  This thick slime will completely clog a perimeter drain, and will permanently stain nearly anything it touches.  The slime can have a foul, musty odor, and can ruin clothes and the taste of water. 

Unfortunately, there is no ideal way to handle this problem.  However, many contractors now offer a basement drain system that's custom-designed to handle this – complete with a removable lid (so the ocher can be scooped out as it builds up) and a powerful sump pump system that will continue to pump water out unabated. 

All of these potential sump pump tragedies are important things to look for when it comes to owning and maintaining your home's sump system. Ranging from puddles on your basement floor to harmful bacteria, your sump system is a vital component to a dry basement.  

No matter what challenge your wet basement holds, Midwest Basement Systems has a solution that will work for you!  Our experts are available throughout Central Iowa. Our specialists are standing by to help you transform your basement into a space that's dry – all the time!

our service area

We serve the following areas

Our Locations:

Midwest Foundation Repair
9850 Douglas Ave Suite 100
Urbandale, IA 50322
1-515-992-7046
Top